Configure a cluster
IMPORTANT
There is usually no need to change cluster configuration parameters. You can leave all parameters at the default values.
|
After creation a new cluster, you can configure it by performing the following steps:
-
Select a cluster on the Clusters page. To do this, click a cluster name in the Name column.
Select a cluster -
Open the Configuration tab on the cluster page and switch on the Show advanced toggle.
-
Fill in all necessary parameters and click Save.
Cluster configuration parameters are listed below:
-
Paths to the repositories that are used during the installation process depending on the cluster operating system (CentOS, Red Hat, ALT Linux 8 or Astra Linux). Only the marked repositories are registered on the cluster servers.
RepositoriesParameter Description monitoring
YUM repository for installing monitoring
zookeeper_repo
Arenadata Zookeeper YUM repository
ADS
ADS YUM epository
ranger plugins
repository for installing Ranger client (only for Enterprise version)
-
Znode path for cluster in Zookeeper service — Znode path for the ADS cluster in the Zookeeper service.
-
BASIC Authentication — configuration for BASIC authentication.
For a description of enabling authentication, see the article Basic authentication.
-
SASL_PLAINTEXT Authentication — configuration for SASL PLAINTEXT authentication.
For a description of enabling authentication, see the article SASL PLAINTEXT.
-
Kerberos — configuration for Kerberos authentication.
The description of enabling authentication is given in the articles:
-
java.io.tmpdir — a Java system property that determines where the JVM writes temporary files.